Removing cam chain sprocket

stupid question time.
You can't remove the cam chain sprocket from the intake cam can u?!??

I was looking at one of these.
[You must be registered and logged in to see this link.]

[Mod Edit]Split this off, as it's a separate question . Beigy

I'd imagine they are and interferance fit, requiring a bit of heat and a puller/press? Maybe?

ah,ok.
thnks.

They press of. However word of warning these are a nightmare to setup and you run the risk of bolts coming undone inside the head. So only invest if you are going to have positive gains from it. i.e. on a standard cam you wont.
Alternativelly fiddling with overlap to change to FI it is feasible but you need to get the right cam profiles first.

hmm..ok;thanks.
I'll have a good think about it.

yes, ive had them pressed off in the past to have new keyways cut.

Expensive fookers aswell...,i welded on my exh-as-inlet cam's sproket.

^^^^ why? You are aware all you have to do is flip the sprocket over so the teeth align correctly and then remark th TDC point?