OddUnit

conrod small end offset bushing

Go down

conrod small end offset bushing

Post by dirtytorque on Fri Aug 21, 2009 5:37 am

anyone know where I can ger this done to a desired compression ratio?
Can't get through to stealth at the moment.I believe they use to do it?!!
avatar
dirtytorque
.:Charged:.
.:Charged:.

Number of posts : 1101

View user profile

Back to top Go down

Re: conrod small end offset bushing

Post by mrbeige on Fri Aug 21, 2009 5:43 am

Pretty sure Kev's 16vT had this done??

_________________
Stu
"Take one old performance car, modify it so that it is as good, if not better, than a new performance car"

£300 Corrado 1.8 16v
The good lady wife's Golf VR
avatar
mrbeige
.:Admin:.

Male Number of posts : 1384
Age : 41
Location : Near Ely, Cambs.......but another planet according to my wife....

View user profile http://www.oddunit.com

Back to top Go down

Re: conrod small end offset bushing

Post by kevhaywire on Fri Aug 21, 2009 6:01 am

Stealth might be on holiday. I know they shut up shop for a week round about this time of year.

But yep, they used to do that a fair bit back in the days of the 16V T. I don't know if they did it in house or bought in special bushes.

kevhaywire
.:Stroked:.
.:Stroked:.

Number of posts : 605

View user profile

Back to top Go down

Re: conrod small end offset bushing

Post by JNLRacing on Mon May 17, 2010 2:19 am

It's easily enough done allthough not a fan of it as it gives too much meat for wear and tear on the small end. Causing premature small end knock on lift off.

Safer to either make up a custom multilayer gasket by stacking or machining the crowns of pistons. All comes down to how much boost you are running on what engine configuration.

JNLRacing
.:Cammed:.
.:Cammed:.

Number of posts : 205

View user profile

Back to top Go down

Re: conrod small end offset bushing

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum