Tubbs
+6
peanut
Sonicriot13
Toad
dirtytorque
CorradoVR6-Turbo
mrbeige
10 posters
OddUnit :: The Workshop :: Projects
Page 4 of 4
Page 4 of 4 • 1, 2, 3, 4
Re: Tubbs
Well, I fixed it. Thanks for the encouragement guys. It was the passenger ABS sensor. Got a replacment from ebay for £15. I got the car up on blocks today (makeshift axle stands). The old sensor was a biatch to get out (see attached). 4 pieces eventually as the metal had rusted to the hub. Oh, and I did need a hammer .
[You must be registered and logged in to see this image.]
The the new one was a bloody tight fit too. Has gone in though and seems to have cured the problem. Will check the fixing of it in a few days when everything has had chance to have a run in and make sure the bolt is still tight.
[You must be registered and logged in to see this image.]
The the new one was a bloody tight fit too. Has gone in though and seems to have cured the problem. Will check the fixing of it in a few days when everything has had chance to have a run in and make sure the bolt is still tight.
jmc- .:Bored:.
- Number of posts : 271
Age : 51
Location : Egham, Surrey
Re: Tubbs
Finesse is cool but every now and then u just need to break out the hammer Lol.
dirtytorque- .:Charged:.
- Number of posts : 1101
Re: Tubbs
Ans if he hammer doesn't work, it's an electrical problem!dirtytorque wrote:Finesse is cool but every now and then u just need to break out the hammer Lol.
Re: Tubbs
Ordered a rear engine mount and upper and lower chain guides today. Will be ordering a clutch kit and release arm from Joe tomorrow.
Re: Tubbs
Just bought a set of Erwin Bolt-grips of eBay for £15 delivered, and finally bought a breaker bar!
Re: Tubbs
Time for a small update. Mic has just upgraded his Corrado 24v VR with some fancy new 17" Rotas and AP 4-pots, so his old wheels were going spare, and I thought it would be rude not to put them on the VR. Nice to finally get shot of the scabby standard BBS wheels and fit something a little bit bit different. Excuse the state of the car, she needs a bit of a wash.....
[You must be registered and logged in to see this image.]
[You must be registered and logged in to see this image.]
Re: Tubbs
Not a lot at the moment. Still plan to do the chains/clutch in the near future. Got a dodgy A/C pump too!
I'd love to supercharge it, but that's pie in the sky at the mo...
I'd love to supercharge it, but that's pie in the sky at the mo...
Page 4 of 4 • 1, 2, 3, 4
OddUnit :: The Workshop :: Projects
Page 4 of 4
Permissions in this forum:
You cannot reply to topics in this forum
|
|